QinReno said:Check that the water seal around the rim of that shell looks good. Just cover over the windows with masking tape and newspaper, and the painting would go quickly. If I were getting a tent extension, I'd get one that comes out far enough to form an awning to set 2 or 3 chairs under, plus a table to cook on. That would make a nice setup.
closeanuf said:That red camper kinda looks like mine. You can build a bed on one side and sit on the bed and have headroom. If you buy it I'll figure out a way to show you pictures haw I did mine.
Carla618 said:Can a tarp be used to cover the bed of a truck at high speeds? Or would it be shred to bits?
bullfrog said:I bet cardboard could be glued/ taped together to cover it and a canvas drop cloth from Harbor Freight glued with Titebond III then painted with opps exterior house paint inside and out would last several years, even longer if you just bolted a few sheets of thin quality plywood on it and then covered it as stated previously. I built one out of interior doors glued together with little or no support covering it this way and it has lasted years.
DannyB1954 said:You could custom fit a tarp using a grommet kit. I just bought some plastic grommets at Home Depot garden compartment. The two halves snap together with pliers or a hammer, then you cut out the material that is in the hole of the doughnut. This would make it easier to put back on.
bullfrog said:Having a standup enclosure in your truck puts you in better shape than most van dwellers having to deal with back problems because they cann't, even if it is just a tarp you will be able to. <snip> George of George and Tioga web site fame at 81 has decieded to build out a box truck having never done it before he will make mistakes, but he enjoys fixing his mistakes.
LexSleuther said:Not trying to sell you on a topper, but the beauty of these things is that you have an instant "shell". everything inside is flexible (the ultimate clean slate), do-overs are a piece of cake, and you didn't spend a lot of money. If you can relax your constraints (must be able to stand up inside), or plan on adding height via "sidewalls" at some point, a topper might be the most inexpensive route ...
<snip>
Hope this helps ...
outermostsoul said:I have an old truck 1970 and had a heck of a time trying to find a topper to fit a real full size pick up bed. I finally found one that worked but the guy was rock solid on his price and it took a full days drive to go get it but sleeping in the back with my dogs at the truck-stop coming home was great. I have an all steel Caveman topper with wool felt insulation, a bed that goes sideways right against the cab and two slider windows.
Enter your email address to join: