I replaced the rubber connector on the Inlet side on the pump too. Maybe it just needed some time to get air out of the pump? I ran it on full blast for hours yesterday and this morning tried starting it and got error 08. Tried again and it started on 5.5 hz, my thinking was the more fuel it’s pumping the more the air bubbles will work their way out.
I do plan on getting some spares now, is there a controller I can buy to hook up to this. Not sure if mine is broke or what but I have zero controls other than off-on and hertz up/down.
I was planning before if started messing up to install another heater in my (garage area) in my van. To have back up heat and to be able to keep my batteries and water warmer and stuff dryer.
I was thinking of getting the small 2kw or 5kw one, (The one I have now is 8kw) is there a brand you prefer? And do you usually use the clamps and rubber connector hose or different?
I do plan on getting some spares now, is there a controller I can buy to hook up to this. Not sure if mine is broke or what but I have zero controls other than off-on and hertz up/down.
I was planning before if started messing up to install another heater in my (garage area) in my van. To have back up heat and to be able to keep my batteries and water warmer and stuff dryer.
I was thinking of getting the small 2kw or 5kw one, (The one I have now is 8kw) is there a brand you prefer? And do you usually use the clamps and rubber connector hose or different?