Hi Stargazer, thanks for the thoughts. Some good points.
I had seen an older Dodge van that had a partition that ran across the space from the rear of the slider with no access to the rear. I liked the idea of that work space separate from the (mainly) sleeping area which led me to consider splitting the side-doors with the bulkhead. In my case sleeping in urban areas would necessitate a stealth approach.
Click pic to see posting
If a wall is built across the front, as I understand you have described, will that make it more difficult to get into or out of the living space?
That's why I'm trying to get the dimensions. I just do not know if that will work using one door.
Will you be able to open the "primary" door from the living space? And from the driver's seat, how will you get to the rear? Depending on how it's built, think about that. And if you ever decide to turn a front seat to face the rear for comfortable seating while parked, what will that do?
The new bulkhead would have a door in it, the plan is to separate the entrance from the rear. Makes it easier to have a light on, work at the computer or watch a movie without broadcasting to the outside world.
This is not for RV'ing so an extended lounge area not required but otherwise a valid point. Someone on youtube actually had a La-z-Boy turned toward the rear.. Sensible in that they can go back into a bed pretty much. Still the ugliest things on the planet.
If it's across the rear, the side doors will allow much better access to the living space from inside or outside. I almost never enter/exit from the rear doors as there is no step and it's high enough that I have to step up using the hitch receiver. Not too safe, especially when wet.
It is likely I will end up with an extended van so the rear would house clothes on the driver side and an actual cargo area (albeit limited) on the passenger side so the side door will be the entrance.
Another consideration is that I may get to use it as a cargo van to pick up lumber. If I can have an opening fro the rear that I can slide a hundred or so 10-12' (1"x2") lengths in that would be ideal. It would go under the bed and through whatever bulkhead I end up with.
Small spaces require multiple uses for the same areas.
One other point to consider...if you are parked next to another vehicle, or one parks next to you, will you be able to get the bike out from the side?
This is a god point. I'm assuming most of the time I will be parallel parked on the street but regular parking lots could be problematic.
Whatever you decide to do initially, after living in it for a while, you will probably make a few changes anyway.
So true. Step one after getting the van is to put a bed in it and make that area stealthy if only temporary, then go from there as my needs develop.
Btw, my van is an '05 E-150, regular height and length. With the right barn door open, measuring the narrowest part of the opening (rubber gasket of the closed left door to the inside panel of the open right door) is approximately 22".
Thanks for that info. The Ford documentation shows the opening as 47.1"for an '04 but that is probably the widest with both doors open.
Thanks again and too others that have replied.