Yesterday I bought a 4x8 sheet of plywood for part of the Yeti's flooring. I knew I needed more than that - there's about 12' to cover - but I wasn't sure exactly how much, so I decided to wait until I got home and did some more measuring.<br><br>But now that I'm looking more carefully at what's on the floor I'm seeing stuff that will get in the way of any extra plywood I put down. I knew I would have to work around the wheel wells but now I also see a heater vent just in front of the driver's side wheel well and there's an unknown something in front of that. And behind the wheel wells there's a spare tire on the passenger side and the battery compartment on the driver's side. (Sorry - the pic I tried to take with my phone today is too dark. Will try again tomorrow with a better camera...)<br><br>I definitely need more plywood for that 4' or so in the main back area and fortunately Home Depot does sell smaller pieces so I don't need to buy another big sheet. But what do I do with those small spots? That would be an awful lot of cutting for them to do and I'm not sure they'd do that. But if I don't put something there, there will be a pretty big height difference between the plywood (and the tile I bought to go on it) and the van floor. Even if I try covering it with furniture it won't sit straight; the front will be higher than the back.<br><br>Suggestions, anyone? Has anybody had to deal with this, and if so what did you do?<br><br>Thanks!<br><br>Meg<br><br>