Clan Graham
Well-known member
- Joined
- Aug 19, 2013
- Messages
- 190
- Reaction score
- 0
Yuck ... where to even start. please allow me to apologize completely SternWake. You are NOT responsible for my success or failure AT ALL. I never meant to infer that YOU were going to be responsible for my liability in any way either. I ONLY MEANT THAT I HAVE TO CHOOSE A PERCEIVED SINGLE BEST WAY FOR MY NEEDS, AND GO WITH IT. And your kind willingness to so very freely offer up information, and type very well written and easy to understand information made me decide to pick you for obtaining this information. ( Most importantly though, is that MOST of my own research has led me to see that what you have been telling me seems to be echoed the most often in the information I am finding out for myself while researching. Suggesting to me that YOU seem to have a pretty good handle in what many others are also saying.
So please ... feel no pressure. I am responsible for my own well being and welfare bud
Oh man ... I may get in trouble for saying this now .... But, it is the recharging at certain rates, and how to make an entire bus run off of a 12v system, and how to know when and how long to charge them that I do not understand. I was not thinking very well when I posted that I know nothing at all. I thought it may be best to start with a clean slate ... but I accidentally misled you without meaning to. My fault.
I completely understand wiring, soldering, crimping, and using a multimeter. I installed car stereos at a high level for over 25 years. Go ahead and shoot me now for witholding this. LOL
But we never had to worry about discharge rates, and charging properly in car stereo. If we did not have enough electrical power to run a system, we put in a bigger alternator or I would install a fast reacting specialty battery near the amplifiers to act as a huge capacitor. But while electrical basics are the same, setting up and using an electrical system for LIVING in full time plays by it's own set of rules that I do not know anything about yet. And this is the important part right here : You talk about the Newbie learning curve, and how it can be a very expensive learning process for Newbies .... AND THIS IS SOMETHING I CAN NOT AFFORD AT ALL. This is because our future income is PERFECTLY unknown and uncertain. Once this bus is finished to the point of comfortably livable, we will have ZERO income until my wife can finally get awarded Disability for her terminal disease. If I mess something up as expensive as a bank of batteries, I may not have electricity for many months.
So now ... let's move ahead with the basics here ...
#1 - I can take ANY and all measurements needed with my multimeter ( yes, i have several LOL )
#2 - If two Group 24 Marine batteries are a better option, NO problem at all. I can easily wire them in parallel.
#3 - No problem on the GC batteries ... That simply IS what I will use for my house bank. They are the most resilient to overdischarge, and the most tolerant of improper recharge LOL.
#4 - I love the idea of the 3 way switch. I know it depends on me ALWAYS placing the switch in the proper place ... and i can easily do this without forgetting. My batteries and bus depends on me not forgetting.
#5 - You said "These won't be as difficult to replace when you almost inevitably kill them by running them too low and not recharging them properly" .... And it is THIS I need help learning. How NOT to ruin them. I need to learn how not to run them too low, and how to properly charge them up.
And lastly ... as far as removing all house loads from the starting battery. Unless I am mistaken, the ONLY house loads that are currently on the battery are the overhead lights, which I can easily remove. The rest of the electrical I DO plan on using the house batteries only.
I hope this makes it easier for you to make suggestions now, and just wish I would have taken the time to explain my skills, knowledge, and lack thereof better from the start.
So in summary ... What I really need help with is learning about when and how to recharge, how to mainain any batteries which need it, and how to set up the system to switch between the two. Also, are there any particular GC batteries which you recommend ?
Thanks SternWake, and please feel zero pressure or responsibility.
So please ... feel no pressure. I am responsible for my own well being and welfare bud
Oh man ... I may get in trouble for saying this now .... But, it is the recharging at certain rates, and how to make an entire bus run off of a 12v system, and how to know when and how long to charge them that I do not understand. I was not thinking very well when I posted that I know nothing at all. I thought it may be best to start with a clean slate ... but I accidentally misled you without meaning to. My fault.
I completely understand wiring, soldering, crimping, and using a multimeter. I installed car stereos at a high level for over 25 years. Go ahead and shoot me now for witholding this. LOL
But we never had to worry about discharge rates, and charging properly in car stereo. If we did not have enough electrical power to run a system, we put in a bigger alternator or I would install a fast reacting specialty battery near the amplifiers to act as a huge capacitor. But while electrical basics are the same, setting up and using an electrical system for LIVING in full time plays by it's own set of rules that I do not know anything about yet. And this is the important part right here : You talk about the Newbie learning curve, and how it can be a very expensive learning process for Newbies .... AND THIS IS SOMETHING I CAN NOT AFFORD AT ALL. This is because our future income is PERFECTLY unknown and uncertain. Once this bus is finished to the point of comfortably livable, we will have ZERO income until my wife can finally get awarded Disability for her terminal disease. If I mess something up as expensive as a bank of batteries, I may not have electricity for many months.
So now ... let's move ahead with the basics here ...
#1 - I can take ANY and all measurements needed with my multimeter ( yes, i have several LOL )
#2 - If two Group 24 Marine batteries are a better option, NO problem at all. I can easily wire them in parallel.
#3 - No problem on the GC batteries ... That simply IS what I will use for my house bank. They are the most resilient to overdischarge, and the most tolerant of improper recharge LOL.
#4 - I love the idea of the 3 way switch. I know it depends on me ALWAYS placing the switch in the proper place ... and i can easily do this without forgetting. My batteries and bus depends on me not forgetting.
#5 - You said "These won't be as difficult to replace when you almost inevitably kill them by running them too low and not recharging them properly" .... And it is THIS I need help learning. How NOT to ruin them. I need to learn how not to run them too low, and how to properly charge them up.
And lastly ... as far as removing all house loads from the starting battery. Unless I am mistaken, the ONLY house loads that are currently on the battery are the overhead lights, which I can easily remove. The rest of the electrical I DO plan on using the house batteries only.
I hope this makes it easier for you to make suggestions now, and just wish I would have taken the time to explain my skills, knowledge, and lack thereof better from the start.
So in summary ... What I really need help with is learning about when and how to recharge, how to mainain any batteries which need it, and how to set up the system to switch between the two. Also, are there any particular GC batteries which you recommend ?
Thanks SternWake, and please feel zero pressure or responsibility.