<span id="post_message_1272239120">Hi all,<br>I was inspecting my van's high top before installing a couple of flexible solar panels. There is about a 3" inch dip (square shape) towards the back of the high top (near the back doors). The square depression is about 2 feet x 2 feet. <br><br>If I install the panels as is, the panels would not lie completely flush against the high top and would have to dip downwards towards the back where the dip is, leaving a small gap between the panels and the high top. Additionally, with this square depression, I'm concerned that water may pool up here when it rains, either causing damage to the solar panels or wear away the adhesive from the panels.<br><br>Should I install something to fill the square depression so the panels would lie completely flat from front to back? If so, what kind of material would be appropriate? I'm thinking that the material would need to be weather, sun, rain resistant. Would wood treated for exterior use be appropriate? Thanks everyone.<br></span>